OWB Pancake Wings
OWB Pancake Wings Gun Fit: 1.5 OWB Pancake Wings
RCS has remade the pancake holster with our new, nearly unbreakable Pancake Wings. These loops replace your standard belt loops on the holster shell turning it into a close, low profile pancake-style holster. As always, you have options. You can now select your belt size for a more perfect fit. We have added an offset bend in the loops. This allows for a tight, tighter, and tightest fit depending on how you mount the wings. You can mount them to the inside face of the holster with the logo facing outward for the tight fit. This allows the easiest belt threading and gives you more room to seat the grip. Swap the wings front to back and mount with the logo facing inward to give you an even closer pull to your side. Finally, you can mount the wings on the outside face of the holster with the logo facing outward. This will lever the holster even tighter into your side. You can also try mounting the wing higher or lower to adjust the cant angle or even mount them upside down to play with different fore/aft cant and fit options. We encourage you to play with these to find the sweet spot of comfort and concealment. The only rules to follow as you experiment is that the posts should always seat against the pancake and the screws should always seat against the brass eyelet of the holster. The rubber o-ring should always sandwich between the wings and the holster. As always, we recommend that once you find a configuration you like, apply some non-permanent thread locking product to the screws to prevent them from backing out during use and check your gear regularly. Sold in pairs.